Goovilla Shelf Brackets, Heavy Duty Floating Shelf Bracket 6 Inch for 2×4” Wood Stud, 4 Pack L Brackets for Shelves, Black Metal Wall Shelving Brackets, Shelf Support Brackets, 160 lb. Load Capacity

Love these! They are very sturdy and aesthetically pleasing. Would absolutely buy again. They are easy to install, and came with screws, anchors and a small level! All you need is a screwdriver or a drill. They are made well and have good weight capacity. I used it to put up a shelf to keep some plants up there, away from my kittens. And it looks great!

Super sturdy and easy to mount in my catio. The little float really helped. They’re probably over kill for cat shelves but I love the way they look. (Actually they’re invisible) I am sure that they will last a VERY LONG time even with the rain they’ll get. Hardware was quite sufficient though it would’ve been nice to have a few extra screws. The plastic drywall inserts weren’t needed but they cover all bases for mounting variables you. Little pricey but worth it Purfect size and fit for what I needed. I would definitely use them inside if I needed shelves.

Very well made. I have a few solid wood shelves on it and am not worried at all. Very sturdy, thick metal. However, it does come with drywall hardware - which are the good kind, by the way- and I fell for it. Of course it didn't hold up (as I should have guessed). The holes on the product are very close to each other, so by installing the drywall inserts, there was basically no drywall left to actually hold the thing in place. So I ended up with several holes on my drywall after it gave in. Once installed on studs though (as I should have done since the start because my shelves are heavy), it was perfect.

I wanted a floating shelve look, but the wood was only 1" thick, so I decided to use these brackets rather than drilling through the wood to insert rods. This did not impact the integrity and strength of the wood. In the photo, I used walnut 10" x 60" x 1" wood (which I polished and sealed). I also used all four brackets included in the kit I ordered to prevent sagging of the sleeve due to weight, as it is intended to hold books. Technically, I could have only used three brackets (remember this is a 5-ft shelve), but there were no studs in the center, so I used all four (overkill) just for aesthetics. I also aligned them with a 6-ft level and a laser beam. Needless to say, I Love the look. Word of caution: locate the stud edges to center the brackets properly, as there is little room for error. Side note: I also built the custom desk below the shelf, but that is another story.

Love these, they’re strong, heavy duty. No bracket seen below shelves. Easy to install. I did have to buy long screws The ones that came with were rather short. For extra reinforcement, got a bit longer